6 / 4 R Slurry Pump , Slurry Transfer Pump Natural Rubber Spare Parts

6 / 4 R Centrifugal Heavy Duty Slurry Pump With Natural Rubber Spare Parts

Main introduction of slurry pump

The slurry pump is a single-stage single-suction, cantilever, horizontal centrifugal slurry pump. This type of pump has a thick bearing and is equipped with a heavy-duty bracket, so it is suitable for conveying strong abrasion, high concentration slurry or low concentration high lift slurry. It can be used in multiple stages in series within the range of the pump's large allowable working pressure. The pump can also be used to transport a corrosive slurry.

The slurry pump has a replaceable rubber lining and the impeller is made of rubber. The shaft seal can be a packing seal or a centrifugal seal. The pump's discharge port can be installed at a different angle from 45°C and rotated at eight different angles.

Model meaning

6 / 4 E - R

6------------Suction diameter(Inch)

4------------Discharge diameter(Inch)

E-----------Support type

-------- Pump Model

R-----------Natural Rubber

Specifications

Use

In the coal washing industry, due to different working conditions, large coal blocks and coal gangue are easy to block, and the design requirements for the slurry pump are very high. In 2005, a coal washing plant in Indonesia adopted a specially designed replacement of the slurry pump imported from Australia. It has been operating normally, transporting large coal blocks and coal gangue without blockage, and the wear life exceeds that of imported pumps.

Typical Applications:

Ash Handling

Cyclone Feeds

Pulp and Paper

Abrasive Slurries

Coal Preparation

Mineral Processing

Aggregate Processing

Construction Design

Shaft Seal Module Design

Performance table